BRP Evinrude E-TEC G2 Service Manual page 178

Fuel System
Fuel Component Servicing
Select the Open button.
1. Drop down menu
2. Injector coefficient file
3. "Open" button
After the upload is complete, the program will
return to the Injector tab.
Make sure the serial number displayed on the
screen matches the serial number printed on the
serial number label of the replacement injector.
1. Injector serial number
Install Injector
NOTICE
Confirm injector location when assembling
the injector bank. Refer to cylinder location
marks made earlier. Improper injector instal-
lation can result in powerhead failure.
Assemble the injector bank:
178
•
•
•
•
1
•
•
2
•
3
009213
The following items and their mating surfaces
must be cleaned before reassembly:
•
•
•
•
1
IMPORTANT:
or hoses during assembly.
Lubricate mounting screw threads and under the
009285
head of the screw with a light coat of Triple-Guard
Install new o-rings on the fuel fitting, each fuel
tube and the plug fitting.
Apply 2-stroke outboard oil to the o-rings.
Install the fuel fitting in the top injector.
Install the retaining screw and tighten to a
torque of 84 to 106 in. lbs. (10 to 12 N·m).
Install the plug fitting in the bottom injector.
Install the retaining screw and tighten to a
torque of 84 to 106 in. lbs. (10 to 12 N·m).
Align the injectors with the fuel tubes and press
together until fully seated.
Injector
Cylinder head
Screws
Threaded areas
CAUTION
All injector components must be clean to
ensure correct torque tightening specifica-
tions. To prevent fuel leakage, carefully fol-
low these installation instructions.
Be careful not to pinch any wiring
009210