BRP Evinrude E-TEC G2 Service Manual page 326

Stern and Swivel
Trim & Tilt System Service
Install four filters and o-rings into the swivel
bracket. Install the large diameter o-ring in the
position shown.
1. Large o-ring
Position the manifold assembly close to the swivel
bracket. Install the trim motor cable and trim
sender lead through the port side of the swivel
bracket.
2
1
1. Trim motor cable
2. Trim sender leads
Carefully place the manifold assembly into posi-
tion on the swivel bracket. Take care to keep
o-rings in position on the swivel bracket.
326
1
009433
009450
Install the four hex screws into the trim manifold.
1. Four hex screws
Tighten screws in the sequence shown to a torque
of 18 to 20 Ft. lbs. (24.4 to 27 N·m).
2
4
Tightening Sequence
Install the trim sender on the port stern bracket.
Refer to Trim Sender Service on p. 344.
3
1
2
1
009433
1
3
009449