Shift Actuator Service; Shift Actuator Removal; Shift Actuator Installation - BRP Evinrude E-TEC G2 Service Manual

Hide thumbs Also See for Evinrude E-TEC G2:

Table of Contents

Shift Actuator Service

Remove the gearcase, refer to Gearcase

Removal on p. 361.

Remove the six screws retaining the shift actuator

to the gearcase housing.

Lightly tap the shift actuator with a soft mallet to

loosen it. Then slide the shift actuator forward and

lift to remove.

Remove the shift actuator seal and discard it.

Remove all old gasket sealing compound from the

shift actuator and gearcase housing.

1. Gearcase housing

Check shift rod height BEFORE installing the

shaft actuator. Refer to Shift Rod Adjustment

Use Evinrude Diagnostics software (version

6.1 or later) to calibrate the shift actuator

when installing a new gearcase or shift actua-

tor. Failure to calibrate the shift actuator can

result in damage to the shift actuator.

Table of Contents

E 250 l ho ag b