Cylinder Drop Tests - BRP Evinrude E-TEC G2 Service Manual

Cylinder Oil Pump Static Test
The EMM controls the pump by providing ground
through pin 10 (blue/orange wire) of the J3 con-
nector and pin B (blue/orange wire) of the oil
pump connector.
Use the Cylinder Pump test of Evinrude Diagnos-
tic software Tests screen to activate the oil pump.
This test activates the EMM control function for
the oil pump.
1
Tests Screen
1. Cylinder Pump button
Use an inductive timing light to monitor current
flow through the ground circuit (blue wire) at the
oil pump connector (pin B).
Results:
•
If the light flashes, the EMM and oil pump cir-
cuits are not at fault.
If the light does not flash, refer to Oil Pump Elec-
trical Tests on p. 198.
Dynamic Power Steering (DPS)
Use the Power Steering screen of Evinrude Diag-
nostics software to observe DPS system reactions
while turning the steering wheel.
Power Steering Screen
009225
System Analysis
Static Tests
5
009401
107