BRP Evinrude E-TEC G2 Service Manual page 345

Remove the cover and o-ring
2
1. Cover
2. O-ring
Use Spanner Socket, P/N 359224, to remove the
spanner nut.
1. Spanner nut
Remove the locking washer. Then make an align-
ment mark on the splined steering shaft and steer-
ing arm to aid re-assembly.
1. Alignment mark
Remove the steering arm from the steering shaft.
1
009645 1. Steering arm
End Cap Removal
Remove the steering arm from the steering shaft.
Refer to Steering Arm Removal on p. 344.
Remove the two screws retaining the steering
position sensor, and remove the steering position
1
sensor.
009646
1. Screws
2. Steering Position Sensor
Use a T-40 Torx driver to remove the eight screws
retaining the end cap assembly.
1
009655
1. Screws
Stern and Swivel
Stern & Swivel Bracket
1
1
2
1
009647
009648
1
13
009648
345