BRP Evinrude E-TEC G2 Service Manual page 404

Gearcase
Shifter, Bearing and Seal Servicing
Install the magnet into the shift lever, aligning the
hole in the magnet with the holes on the shift
lever.
2
1. Magnet
2. Hole on shift lever
With shifter detent in NEUTRAL, install arms of
shift lever into detent slots. Align the pivot holes
and insert the retaining pin. Push shifter detent
down.
1
2
1. Shifter detent
2. Shift lever
3. Pin, shift lever
Rest the cradle on the shift shaft.
Place the shift lever arms into the recesses of the
shift cradle. Pull shifter detent back up to NEU-
404
TRAL position to hold the cradle and shaft in
place.
1
1. Cradle
2. Shift shaft
009524
Coat thrust bearing and thrust washer with Needle
Bearing grease. Place the bearing on the back of
the gear. Set the washer on top of the thrust bear-
ing. Insert the gear, bearing, and washer into the
bearing housing.
Wear safety glasses to avoid injury.
If these parts are damaged or removed, a new
service kit should be installed. Refer to parts cata-
log for kit part number.
3
009556
1. Clutch Shaft Retainer Kit
2. Clutch Shaft
Coat thrust bearing and thrust washer with Needle
Bearing grease. Place the bearing on the back of
the gear. Set the washer on top of the thrust bear-
1
WARNING
2
2
009525
1
009560