BRP Evinrude E-TEC G2 Service Manual page 181

Remove the:
•
center frame spacers and mounts from the ple-
num.
•
Oetiker clamp from the vapor solenoid vent
hose, then remove the vent hose from the ple-
num.
•
electrical connector from the air temperature
sensor.
3
1. Oetiker clamp and vent hose
2. Electrical connector
3. Center frame spacers and mounts
Remove 18 retaining screws from the plenum,
then remove the plenum and gasket.
1. 18 retaining screws
3
1
2
009189
1
009190
Fuel Component Servicing
Remove the tie straps and oil recirculation hoses
from the reed plate assembly.
1
1
1. Tie straps and oil recirculation hoses
(oil fill hose removed for clarity)
Remove 5 retaining screws from the reed plate
assembly, then remove the reed plate and gasket
from the crankcase.
1
1
1. 5 screws
Disassembly
All reed plate assembly and reed valve assem-
blies must be cleaned before reassembly. DO
NOT use strong carburetor cleaner or the hot
soaking tank method for cleaning.
Fuel System
009191
1
1
1
009192
181
7