BRP Evinrude E-TEC G2 Service Manual page 312

Stern and Swivel
DPS Module Service
IMPORTANT:
Make sure outboards do not con-
tact. Slowly turn the steering wheel, while an assis-
tant manually moves the disconnected outboards.
4. Then press the Set Port button. The button will
deactivate while saving the PORT end point.
Wait for the button to activate BEFORE con-
tinuing.
5. Slowly turn the steering wheel until the out-
board is turned fully to STARBOARD.
IMPORTANT:
Make sure outboards do not con-
tact. Slowly turn the steering wheel, while an assis-
tant manually moves the disconnected outboards.
6. Then press the Set Starboard button. The but-
ton will deactivate while saving the STAR-
BAORD end point. Wait for the button to
activate BEFORE continuing.
7. Select Disable Calibration to save the setting
and re-enable the power steering pump.
1. Set Port
2. Set Starboard
3. Disable Calibration
Before calibrating the SECOND DPS outboard:
•
turn the key switch to the OFF position.
•
disconnect the battery cables at the battery for
the FIRST DPS outboard
•
connect the battery cables at the battery for the
SECOND DPS outboard
•
Turn the key switch to the ON position
Start the diagnostic program. After the program
connects to the network, select from the device list
the Engine Controller (EMM) for the SECOND
DPS outboard. Then select the Power Steering
button.
312
8. Repeat steps 1 through 7 for the SECOND
DPS outboard.
After completing end points calibration, calibrate
the turn limits. See Calibrate Turn Limits on
p. 312.
Calibrate Turn Limits
Before calibrating Turn Limits:
•
connect tie bar(s) to the outboards
•
adjust outboard alignment
•
in 3 or 4 outboard installations disconnect the
battery cables at the battery for the SECOND
DPS model outboard
Turn the key switch to the ON position, then start
the diagnostic program.
After the program connects to the network, select
from the device list the Engine Controller (EMM)
for the FIRST DPS outboard. Then select the
Power Steering button.
1. Select Enable Calibration. The power steering
pump is disabled while in calibration mode.
3
2. Then be SURE to select Turn Limits.
1
2
009399
1. Turn Limits
2. Turn the steering wheel until the outboards are
turned fully to PORT. Then press the Set Port
button. The button will deactivate while setting
the PORT turn limit. Wait for the button to acti-
vate BEFORE continuing.
3. Turn the steering wheel until the outboards are
turned fully to STARBOARD. Then press the
Set Starboard button. The button will deacti-
vate while setting the STARBAORD turn limit.
1
009400