BRP Evinrude E-TEC G2 Service Manual page 141

use Primary Lock Tool, P/N 777077, to release
locking tab of connector housing. Release locking
tab and pull on wire to remove from connector
housing.
1
1. Locking device, plug
2. Locking device, receptacle
1. Locking tab, plug
2. Locking tab, receptacle
Terminal Installation
Align terminal with connector housing. Push con-
nector and seal into housing until seated.
1
1. Terminal and seal
2
002449
002450
2
1
002447
002451
Align locking device with connector housing and
terminals. Use Secondary
P/N 777079, to seat device in connector.
Crimping Terminals
Crimping Superseal 1.5 terminals requires AMP
Crimp Tool with dies, P/N 777281.
2
1. Terminal
2. Seal
S S
UPER EAL
The J1-A, J1-B and J3 connectors of the EMM are
AMP Super Seal connectors.
Disconnect
Depress BOTH latches and pull connector from
plug.
Connect
Push connector into plug until latches engage.
1
1
J1A and J1B Connectors
1. Latch
Electrical and Ignition
Connector Servicing
Lock Installer,
1
002452
009382
141
6