Electric Motor - BRP Evinrude E-TEC G2 Service Manual

Stern and Swivel
DPS Manifold Service
Install tie strap, P/N 320107 to secure sensor lead
to sensor as shown.
1. Tie strap
IMPORTANT:
DPS-2 Pressure sensors use a
clamp-on ferrite suppressor. Remove the suppres-
sor from the old sensor. Install the suppressor on
the sleeve of the new sensor, within 2 to 4 in. (50
to 100 mm) of the electrical connector.
1. Ferrite suppressor
Be sure to calibrate the steering pressure sensors
after the DPS manifold is re-installed on the out-
board.
Refer to Steering Pressure Sensor Calibration
(AFA and Newer Models Only) on p. 309.
322
1
009455
2 to 4 in.
(50 to 100mm)
1
009746

Electric Motor

Remove the four screws and washers retaining
the electric motor to the manifold housing.
1
1. Screws and washers (3 shown)
Remove the electric motor, o-ring and coupler
from the manifold housing.
1
2
1. Electric motor
2. O-ring
3. Coupler
Clean and dry all parts thoroughly.
Assembly is the reverse of disassembly. Tighten
screws to a torque
(7 to 10 N·m)
1
1
3
of 60 to 84 In. lbs.
009459
009460