BRP Evinrude E-TEC G2 Service Manual page 325

Remove the four trim manifold o-rings from the
swivel bracket.
1. Four trim manifold o-rings and filters
Remove the four trim and tilt filters from the swivel
bracket.
1
1. Filters
Installation
Service replacement manifold assemblies may
have filters installed, or included in the packaging.
Be sure to install new filters and o-rings before
installing the trim and tilt manifold assembly.
IMPORTANT:
Identify filters and o-rings and en-
sure they are installed in the correct locations.
The Trim and Tilt Manifold uses:
•
4 Filters, P/N 356937, which are 0.875 in.
(22.4 mm) long,
1
1
1
1
009451
009441
Trim & Tilt System Service
•
3 O-rings, P/N 326956, which are 0.299 in.
(7.6 mm) inside diameter, x 0.103 in (2.6 mm)
thick
•
1 O-ring P/N 318372, which is 0.306 in
(7.8 mm) inside diameter x 0.179 in. (4.5 mm)
thick.
Install one o-ring on each oil filter as shown.
1. Filters
Insert a filter and o-ring into each oil passage.
Continue to push the filter and o-ring into the oil
passage until the o-ring expands into the
recessed seal area. The filter should protrude
slightly to hold the o-ring in position.
1
4
1. Filter and o-ring
2. Oil passage (sectioned view)
3. Recessed seal area
4. Filter and o-ring in position
Stern and Swivel
009443
2
3
009442
325
13