BRP Evinrude E-TEC G2 Service Manual page 173

device and push to unlock the quick connector fit-
tings.
1
1. Lift tabs
2. Push tabs to unlock
Push the locking device to lock the quick connec-
tor fittings. Make sure tabs are in the locked posi-
tion.
1
1. Push locking device
2. Tab in locked position
Removal
Relieve fuel system pressure. Refer to Relieving
Fuel System Pressure on p. 168.
WARNING
When servicing the fuel system, always shift
the outboard to NEUTRAL position, turn the
key switch OFF and remove the key, so the
outboard cannot be started accidentally.
Disconnect the battery cables at the battery.
Remove the engine top, front and rear covers.
Remove the port and starboard side panels.
Remove the starboard frame. Next remove the
port frame, then remove the front frame.
Use a #2 Posi-drive screwdriver to remove the
three screws retaining the center frame to the
frame mounts.
Remove the center frame. Refer to Engine Cover
and Frame Service on p. 55.
Unlock and remove the quick connectors from the
fuel pump & vapor separator assembly.
Use shop towels to wipe up any spilled fuel.
2
009195
1. Quick connector fittings
2
Unlock the quick connectors from the fuel injec-
tors.
Remove the quick connectors from the fuel injec-
tors.
Use shop towels to wipe up any spilled fuel, then
remove the connectors from the fuel injectors.
009196
Dispose of fuel contaminated towels in an envi-
ronmentally responsible manner, or according to
local regulations.
Remove the fuel rails from the engine.
Fuel System
Fuel Component Servicing
1
ENVIRONMENTAL NOTE
1
009216
7
009215
173