Before Start-Up - BRP Evinrude E-TEC G2 Service Manual

Routine Service

Before Start-Up

Before Start-Up
Gearcase Lubricant
With outboard vertical, check the gearcase lubri-
cant level:
•
Inspect the lubricant level in the lubricant reser-
voir.
1
1. Lubricant reservoir
•
Lubricant level should be between the marks as
shown.
{
{
1.5 in.
(38 mm)
Lubricant Level
1. Maximum
2. Minimum
Add HPF PRO gearcase lubricant if needed.
2-Stroke Engine Oil Level
Make sure the outboard is in the vertical position
when checking oil level. Use the digital gauge or
display to check the oil level. Make sure the on-
board oil tank contains an adequate supply of the
correct lubricant for the outboard. Refer to Rec-
ommended Lubricants on p. 192.
38
009140
1
2
009141
Trim and Tilt Fluid
CAUTION
Correct fluid level must be maintained to
ensure operation of the impact protection
built into the unit.
The trim and tilt system is filled, tested and sealed
at the factory. It is NOT necessary to check fluid
level.
Check the fluid level ONLY if the trim and tilt is
NOT operating normally:
•
Tilt the outboard to the full UP position.
•
Remove filler cap and check fluid level.
•
Add Power Trim/Tilt Fluid, P/N 767969, as
needed, to bring level to the bottom of the fill
plug threads.
1. Filler cap
1
009127