Components; Icon Ii Remote Control - BRP Evinrude E-TEC G2 Service Manual

Evinrude ICON II Remote Control System

Components

Components
The ICON II remote control system includes the following components:
•
ICON II remote control(s)
•
Remote control (private) network
•
NMEA 2000 network
Typical Installation
Single outboard system with single lever binnacle remote control shown

ICON II Remote Control

ICON II remote controls are electronic shift and
throttle remote control systems which manage all
engine control functions through a low-voltage,
digital data network.
Sensor inputs and internal EMM controllers are
used to control the operation of the outboard's
shift and throttle functions.
Use Evinrude Diagnostics software to trouble-
shoot the sensors. Refer to the Fault Code Chart
for a complete list of all control system fault codes.
224
_
+
12.5 – 14.7 VDC
•
Up to four Evinrude E-TEC G2 74° V6 out-
boards
OFF
ICON II remote controls are available in the fol-
lowing configurations:
•
Single Lever Binnacle Mount, use in single out-
board, single or dual station installations
•
Concealed Side Mount, use in single outboard
installations. May be used with an optional
accessory foot throttle.
•
Dual Lever Binnacle Mount, use in multiple out-
board (up to 4), single or dual station installa-
tions.
ON
START
R
009373