Plug Installation - BRP Evinrude E-TEC G2 Service Manual

complete engine. The off-set lifting eye is used to
remove and install the powerhead.
Lifting Fixture, P/N 357667
1. Centerline lifting eye
2. Off-set lifting eye
IMPORTANT:
Carefully thread the lifting fixture
into the threads of the flywheel at least 6 complete
turns. Do NOT cross-thread the threads of the lift-
ing fixture into the threads of the flywheel.
Install the lifting fixture completely into the fly-
wheel. If needed, turn the flywheel until the lifting
rings of the fixture are aligned front to back as
shown.
Back
1
1. Fixture aligned front to back
Fasten appropriate chain hook to the centerline
lifting eye of the tool.
2
1
357667 1. Centerline lifting eye

Plug Installation

Install plugs as indicated. Plugs MUST be
installed to prevent water entry and/or engine
performance issues.
Install the following plugs from the Owner's Kit:
1. Apply Triple Guard grease to the threads of the
flywheel. Then install the Flywheel Thread
Front Plug, P/N 357323 to protect the threads from
corrosion.
009100
1. Flywheel thread protector
Routine Service
Lifting The Outboard
1
NOTICE
1
2
009100
009102
29