Cleaning And Inspection; Installation - BRP Evinrude E-TEC G2 Service Manual

Stern and Swivel
DPS Manifold Service
Remove the four DPS manifold o-rings from the
swivel bracket.
Remove the four trim manifold o-rings from the
swivel bracket.
1
1
1. Four DPS manifold o-rings
2. Four trim manifold o-rings and filters
Remove the four trim and tilt filters from the swivel
bracket.
1. Filters
316

Cleaning and Inspection

Apply cleaning solvent to lint-free shop tow-
els to clean hydraulic oil residue from all sur-
faces.
Do NOT spray cleaning solvent on the swivel
bracket. Solvent can seep into oil passages
resulting in contamination of hydraulic fluids.
2
Use lint-free shop towels to wipe up spilled
hydraulic fluid.
2
2
Dispose of spilled hydraulic fluid or contaminated
shop towels in an environmentally responsible
manner, or according to local regulations.
2

Installation

Make sure ALL mating surfaces of the
009433
DPS/TNT manifolds and stern and swivel
bracket are COMPLETELY CLEAN AND FREE
OF ALL DEBRIS.
Dirt, dust or other contaminants in the
hydraulic system can result in malfunctions
or failures.
Service replacement manifold assemblies may
have filters installed, or included in the packaging.
IMPORTANT:
filters and o-rings are installed in their correct loca-
tions before installing the DPS / Trim and Tilt man-
ifold assembly.
1
The DPS Manifold uses:
•
009441
•
The Trim and Tilt Manifold uses:
•
NOTICE
ENVIRONMENTAL NOTE
NOTICE
Identify filters and o-rings. Ensure
4 Filters, P/N 357367, which are 1 in. (25.4 mm)
long.
4 O-rings, P/N 326956, which are 0.237 in.
(6 mm) inside diameter, x 0.103 in (2.6 mm)
thick.
4 Filters, P/N 356937, which are 0.875 in.
(22.4 mm) long,