BRP Evinrude E-TEC G2 Service Manual page 270

Powerhead
Powerhead Installation
Install the rigging grommets on the powerhead
hoses and buss cables.
1
1. Rigging grommets
NOTICE
Install plugs as indicated. Plugs MUST be
installed to prevent water entry and/or engine
performance issues.
Make sure plugs are securely installed to pre-
vent loosening during engine operation.
Apply Triple Guard grease to the threads of the
flywheel, then install the thread protector into the
flywheel threads. Next install the 3.5 inch plug into
the air duct and install the 4 inch plug into the cen-
ter frame last.
2
1. Thread protector
2. 3.5 inch plug
3. 4 inch plug
Insert the grommets into the front frame, then
install the front frame.
Install the port and starboard frames.
Install the rear covers
Connect all cables, buss cables and hoses from
the engine.Then install the front cover.
270
1
009173
3
1
009425
Refer to Engine Cover and Frame Service on
p. 55.