BRP Evinrude E-TEC G2 Service Manual page 331

Slide both trim rod assemblies out of the trim cyl-
inders at the same time.
Separate the trim rod assemblies from the tube.
1. Tube
Cleaning and Inspection
NOTICE
Apply cleaning solvent to lint-free shop tow-
els to clean hydraulic oil residue from all sur-
faces.
Do NOT spray cleaning solvent on the swivel
bracket or into the trim cylinders. Solvent can
seep into oil passages resulting in contami-
nation of hydraulic fluids.
009579
1
009580
Trim & Tilt System Service
Use lint-free shop towels to wipe up spilled
hydraulic fluid.
ENVIRONMENTAL NOTE
Dispose of spilled hydraulic fluid or contaminated
shop towels in an environmentally responsible
manner, or according to local regulations.
Make sure the are no burrs or debris in the trim
cylinder bores, end cap threads, trim rods, pistons
or seals.
Installation
NOTICE
Make sure ALL surfaces of the trim rod cylin-
ders and replacement trim rod assemblies
are COMPLETELY CLEAN AND FREE OF ALL
DEBRIS.
Dirt, dust or other contaminants in the
hydraulic system can result in malfunctions
or failures.
Apply Power Trim/Tilt Fluid, P/N 767969, to the
trim cylinder bores and to trim pistons and seals.
Assemble the tube and trim rods.
Stern and Swivel
00958
13
331