Dps Module Service; Dps Module Removal; Dps Module Installation - BRP Evinrude E-TEC G2 Service Manual

IMPORTANT:
Calibrate the DPS system after in-
stalling the steering position sensor. Refer to DPS
System Calibration on p. 309.
DPS Module
Service
Cover and Frame Removal
Remove the top, port, front and rear covers. Next
remove the port and front frames. Refer to Engine
Cover and Frame Service on p. 55.

DPS Module Removal

Disconnect the electrical connectors from the
DPS module.
Remove the Oetiker clamps from the upper and
lower cooling hoses, then remove the cooling
hoses from the DPS module.
Remove the ground wire from the ground screw
on the engine block.
Remove the three DPS module mounting screws
and washers.
1
2
4
1. Electrical connectors
2. Oetiker clamps and cooling hoses
3. Ground screw
4. Mounting screws
Remove the DPS module from the engine.
3
4
2
009393

DPS Module Installation

If installing the DPS module on an ABA engine
model, install the Connector and Seal Assembly,
P/N 587328, on the steering position sensor con-
nector.
2
1
1. Connector and seal
2. Steering position sensor connector
Install the DPS module onto the engine.
Install the three DPS module washers and mount-
ing screws. Tighten the screws to a torque of 84 to
106 in. lbs. (10 to 12 N·m).
Install the ground wire onto the ground screw of
the engine block. Tighten the screw to a torque of
84 to 106 in.lb. (9.5 to 12 N·m).
Install the cooling hoses onto the DPS module.
Secure the hoses with new 15.7 mm Oetiker
clamps.
Stern and Swivel

DPS Module Service

009394
307
13