BRP Evinrude E-TEC G2 Service Manual page 336

Stern and Swivel
Stern & Swivel Bracket
Then remove the thread protector from the fly-
wheel threads.
2
1. 4 inch plug
2. 3.5 inch plug
3. Thread protector
Install Engine Lifting Fixture, P/N 357667, com-
pletely into the flywheel. If needed, turn the fly-
wheel until the lifting rings of the fixture are
aligned front to back as shown.
IMPORTANT:
Carefully thread the lifting fixture
into the threads of the flywheel at least 6 complete
turns. Do NOT cross-thread the threads of the lift-
ing fixture into the threads of the flywheel.
WARNING
To avoid personal injury, make sure the lifting
capacity of the hoist is at least twice the
weight of the outboard.
DO NOT allow the lift hook or chain from the
hoist to come in contact with any part of the
engine during lifting.
Make sure the off-set lifting eye is aligned to the
REAR of the engine.
336
1
3
009425
009274
Use the off-set lifting eye to support the engine.
Fasten an appropriate chain hook to the off-set lift-
ing eye.
1
1. Centerline lifting eye
2. Off-set lifting eye (to REAR of engine)
Remove the four lower mount bolts.
1. Lower mount bolts (port side shown)
Remove the two retaining nuts and washers from
the upper mount studs.
1. Nuts
2
1
1
1
009177
009275
009276