BRP Evinrude E-TEC G2 Service Manual page 341

Remove the stern bracket from the tilt shaft.
Remove the thrust washer and o-ring.
2
1. Stern bracket
2. Thrust washer
3. O-ring
Remove the upper screw from the ramp bracket
and remove the ramp bracket.
1. Screw
2. Ramp bracket
Installation
Place the ramp bracket in position on the stern
bracket. Loosely install the upper screw to retain
3
1
009634
1
2
009635
the ramp bracket. The screw will be tightened
later.
1. Ramp bracket
2. Screw
Apply a light coating of Triple Guard Grease into
the o-ring groove on the inside of the stern
bracket. Install the o-ring into the groove.
1
1. O-ring groove
Place the thrust washer onto the tilt shaft. Then
install the stern bracket and o-ring on the tilt shaft.
Make sure the o-ring stays in place on the stern
bracket.
1. Thrust washer
2. Stern bracket
Stern and Swivel
Stern & Swivel Bracket
2
1
009635
009636
1
2
009637
341
13