BRP Evinrude E-TEC G2 Service Manual page 367

Apply Gasket Sealing Compound to the housing
seal and install it into the impeller housing.
1. Seal
Apply Gasket Sealing Compound to both sides of
a new impeller plate gasket. Install the gasket and
impeller plate. Lightly coat the top side of the
impeller plate with Triple Guard grease.
Apply Triple-Guard grease to a new impeller o-
ring. Slide the o-ring down the driveshaft and half
way over installed impeller key to temporarily hold
key in place.
2
3
1. Impeller plate
2. O-ring
3. Key
The sharp edge of the key is the leading edge in
clockwise rotation.
Slide the water pump down the driveshaft. Align
impeller slot with the impeller key. Rotate the
driveshaft to engage the key with the impeller, and
1
5008933-22
1
5008933-23
slide water pump down over key. Be sure impeller
key does not fall out of position.
Rotation
Rotation
NOTICE
Make sure the impeller engages the impeller
key. Serious powerhead damage will result if
impeller key is not in place.
Align the impeller housing with the gearcase.
Apply Gasket Sealing Compound to threads of the
four impeller housing screws. Install the screws
and tighten to a torque of 106 to 127 In. lbs. (12 to
14 N·m).
Gearcase
Water Pump Service
5008933-24
5008933-16
367
14