BRP Evinrude E-TEC G2 Service Manual page 327

If removed, install the plate to the stern brackets
with four screws. Tighten screws to a torque of 18
to 24 in. lbs. (2 to 2.7 N·m).
2 2
1
2
2
1. Plate
2. Screws
Connect the trim motor and trim sender electrical
connectors (starboard side).
1. Trim motor electrical connector
2. Trim sender electrical connectors
Connect the battery cables at the battery.
Install the port, starboard and front frames, and
engine covers. Refer to Engine Cover and
Frame Service on p. 55.
009448
2
1
009171
Trim & Tilt System Service
Manifold Disassembly
Service of the trim and tilt manifold requires
removal from the outboard. Refer to Trim & Tilt
Manifold Service on p. 323.
Separate the fluid reservoir from the trim manifold:
•
Remove two screws and washers from the bot-
tom of the trim manifold
•
Remove one screw and washer from the top of
the trim reservoir
Bottom Of Trim Manifold
1. Two screws and washers
Top of Trim Reservoir
1. Screw and washer
Stern and Swivel
1
1
009464
1
009463
327
13