Propeller Hardware Installation - BRP Evinrude E-TEC G2 Service Manual

Gearcase
Propeller Service
ward, the propeller rotates in a left-hand (coun-
terclockwise) direction as viewed from the rear.
Counter
Rotation
WARNING
For multiple-outboard installations, always
check to be sure propellers are installed on
the correct engines before aggressively oper-
ating the boat.

Propeller Hardware Installation

WARNING
When servicing the propeller, always shift the
outboard to NEUTRAL position, turn the key
switch OFF and remove the key, so the out-
board cannot be started accidentally.
IMPORTANT:
Depending on propeller style, dif-
ferent thrust bushings, spacers, and cotter pin
keepers are used. See the Evinrude/Johnson Gen-
uine Parts and Accessories Catalog for correct
propeller hardware.
Apply Triple Guard grease to the splines of the
propeller shaft before installing the propeller.
360
When installing a propeller with an interchange-
able hub, follow the instructions provided with the
propeller.
1 2 3 4 5
1. Anode screw
2. Anode
3. Cotter pin
Standard
4. Keeper
Rotation
5. Nut
6. Thrust bushing
5008933-04
7. Torsion bushing
8. Thrust washer
IMPORTANT:
board is in NEUTRAL and carefully spin propeller.
Propeller must turn freely and should not spin off
center. If propeller appears to wobble, check for
possible bent propeller shaft.
6
After installation, make sure out-
7 8
5008933-05