BRP Evinrude E-TEC G2 Service Manual page 329

Assemble the manifolds:
•
Install two screws and washers from the bottom
of the trim manifold
•
Install one screw and washer from the top of the
trim reservoir.
Bottom Of Trim Manifold
1. Two screws and washers
Top of Trim Reservoir
1. Screw and washer
Tighten the screws to a torque of 60 to 84 In. lbs.
(7 to 10 N·m).
1
1
009464
1
009463
Trim & Tilt System Service
Electric Motor
Remove the four screws and washers retaining
the electric motor to the manifold housing.
1
1. Screws and washers (3 shown)
Remove the electric motor, o-ring and coupler
from the manifold housing.
1
3
2
1. Electric motor
2. O-ring
3. Coupler
Clean and dry all parts thoroughly.
Assembly is the reverse of disassembly.
Tighten screws to a torque of 60 to 84 In. lbs.
(7 to 10 N·m)
Stern and Swivel
1
1
009459
009460
13
329