BRP Evinrude E-TEC G2 Service Manual page 343

Install the stern bracket plate. Install the four
screws and tighten to a torque of 18 to 24 in.lbs.
(2 to 2.7 N·m).
2
1
2
1. Stern bracket plate
2. Screws
Loosely install the anode and spray plate with two
upper screws.
3
1. Anode
2. Spray plate
3. Upper screws
Position the spray plate and install the two screws
in the bottom of the spray plate.
Tighten the upper screws to a torque of 15 to 23
ft.lbs. (20 to 23 N·m).
2
2
009630
1
3
2
009629
Tighten the bottom screws to a torque of 30 to 60
in.lbs. (4 to 6 N·m).
1
1. Screws
2. Spray plate
3. Anode
Install the spray plate cover with four screws.
Tighten the screws to a torque of 30 to 60 in.lbs.
(4 to 6 N·m).
2
2
1. Spray plate cover (port side shown)
2. Screws
Install the stern and swivel assembly on the boat.
Then install the engine on the stern and swivel
bracket assembly. Refer to Installation on p. 337.
Stern and Swivel
Stern & Swivel Bracket
1
009629
2
1
2
009628
343
13