BRP Evinrude E-TEC G2 Service Manual page 335

Use shop towels to clean up spilled steering fluid.
Install plug and nut assembly in the hose fittings of
the stern and swivel assembly.
1
1. Plug and cap assembly
Install plugs in the hydraulic hose fittings to pre-
vent steering fluid from leaking.
Wipe off any spilled steering fluid.
ENVIRONMENTAL NOTE
Dispose of used oil or oil contaminated towels in
an environmentally responsible manner, or
according to local regulations.
Remove the four screws retaining the rigging cen-
ter. Then remove the rigging center.
1
1. Screws (port side shown)
Disconnect the electrical connectors for the trim
motor and trim sender.
1. Trim motor electrical connector
2. Trim sender electrical connectors
009423
Note the routing of the harnesses for the trim
motor and trim sender. Pull the harnesses back to
the stern and swivel bracket.
If equipped, disconnect the electrical connectors
from the DPS module.
1
1. DPS module electrical connectors
Note the routing of the harnesses for the DPS
motor and sensor. Pull the harnesses back to the
stern and swivel bracket.
Remove the 4 inch plug from the center frame.
009424
Next remove the 3.5 inch plug from the air duct.
Stern and Swivel
Stern & Swivel Bracket
2
1
009171
009172
335
13