Product Part Names - YASKAWA MECHATROLINK Sigma 2 Series User Manual

1 Checking Products and Part Names
1.2

Product Part Names

NS115
The following diagram illustrates the product part names of the NS115.
Ground wire: Connect to the terminal marked "G" on the SGDH SERVOPACK.
S
W
1
A
R
S
W
2
C
N
6
A
C
N
6
B
C
N
4
Fig. 1.3 NS115
Rotary Switch (SW1): Used to set the MECHATROLINK-II station address.
LED A: Lit when an alarm occurs.
LED R: Lit when MECHATROLINK-II communications are in progress.
DIP Switch (SW2): Used to set MECHATROLINK-II communications.
Nameplate: Indicates the model and serial numbers.
MECHATROLINK-II Communications CN6A and CN6B Connectors:
Connects to the MECHATROLINK-II system.
CN4 Fully Closed Encoder Signal Connector: Used for fully closed
signal connection.
1-4