YASKAWA MECHATROLINK Sigma 2 Series User Manual page 184

A.94
A.94: Parameter Setting Warning
Display and Outputs
Alarm Outputs
Alarm Code Outputs
ALO1 ALO2
ON ON
Note: OFF: Output transistor is OFF (alarm state). ON: Output transistor is
ON.
Status and Remedy for Alarm
Occurred when the
command was sent
Cause
A A value outside the MECHATROLINK-II
communications setting range was set.
A.95
A.95: MECHATROLINK-II command warning
Display and Outputs
Alarm Outputs
Alarm Code Outputs
ALO1 ALO2
ON ON
Note: OFF: Output transistor is OFF (alarm state). ON: Output transistor is
ON.
Status and Remedy for Alarm
Occurred when the
command was sent
Cause
A Presently unable to receive the sent command. Adjust conditions to match the command.
B Unsupported command.
9.1 Alarm Displays and Troubleshooting
ALM Output
ALO3
OFF ON
A
Reset correctly.
ALM Output
ALO3
OFF ON
A, B
Refer to the specifications for each com-
mand.
Do not sent unsupported commands.
9-9
Remedy
Remedy
9