Specifying Screen Update Intervals; Using The Operational Mode Screen - Cabletron Systems TRBMIM User Manual

DEVICE STATUS MENU

5.1.4 Specifying Screen Update Intervals

You can use the [
between screen updates. The default interval is 3 seconds.
To specify the update interval:
1. Select the [
REFRESH 3sec
2. Use the Shift>Plus [+] key to increase the value and the Minus [-] key
to decrease the value.
3. Press Enter.
The interval you specified takes effect.

5.1.5 Using The Operational Mode Screen

You can use the Operational mode screen (see Figure 5-2) to monitor the
operational status of all MIM ports under TRBMIM/TRBMIM-T
management control.
Port Operational States
Lobe ports configured for station applications can be in either one of the
following four operational states:
(Enabled)
ENB
(Bypassed)
BYP
(Linked)
LNK
(Inserted)
INS
Ring In/Ring Out ports and lobe ports configured for RO applications can
be in either of the following two operational states:
(Activated)
ACT
(Wrapped)
WRP
5-6
REFRESH 3sec
] field.
The port is enabled to allow an attached station
to insert into the ring.
The port is disabled, and an attached station is
not on the ring.
The port is disabled, and an attached station is
trying to access the ring by transmitting
phantom current.
The port is enabled, and an attached station is
part of the ring.
The port or device is enabled and connected to
the ring trunk cable.
The port or device is in the wrap state.The port
is disabled and there is no access to the ring
trunk cable.
] field to set the time interval in seconds