Re-Configuring A Token Ring Lan Adapter - Cabletron Systems Netlink FRX8000 Installation And Setup Manual

6. At the
[NETLINK]
operational, the FRX8000 Test Menu
To access the menu level on an INM:
1. Press (simultaneously)
2. At the
scosysv!login:
3. When asked for a password, type
4. At the
[NETLINK]

Re-configuring a Token Ring LAN Adapter

If you are installing an FRX8000 that has a Token Ring card, a setup program was
already run to configure the card, and a ring speed of 16 Mbps was selected. The
setup diskettes are shipped with the card, so if you want to change the configured
ring speed, follow the appropriate procedure below.
Intel TokenExpress LAN Adapter
1. Switch the node on or, if already on, press (simultaneously)
reboot. Either way, press
software checking memory. (A number will appear at the upper left of the
screen, and will change as memory is checked.)
2. When asked:
instead of displaying the question, you must repeat step 1.)
3. At the
C:>
then type
4. At the
A:>
5. If only one LAN card (of any type) is installed, go to step 6. If more than one
card is installed, a list of installed cards will be displayed. Select the desired
card by using the arrow keys, then press
6. A menu of setup options will be displayed. Select
.
[Enter]
Installing a Node
prompt, type
start -icp [Enter]
.
[Alt] [F3]
prompt, type
prompt, type
gcon [Enter]
[Ctrl] [C]
Terminate batch job?
prompt, insert TokenExpress LAN Adapter Diskette 1 into drive A,
.
a: [Enter]
prompt, type
tokenset [Enter]
. When the device becomes
(Figure 2-12) will be displayed.
.
netlink [Enter]
.
mypass [Enter]
.
three or four times as soon as you see the
, press . (If the node continue to boot
[Y]
.
.
[Enter]
Manual Setup
to
[Ctrl] [Alt] [Del]
and press
2- 39