Ibm Token Ring Adapter Configuration - Cabletron Systems FRX6000 Maintenance Manual

IBM Token Ring Adapter Configuration

1. Make sure the card is installed, then insert Auto 16/4 Token Ring
ISA Adapter Diagnostic & Configuration Program disk into
drive A and press (simultaneously)
2. When the screen displays
3. At the A:> prompt, type
to display a screen listing all possible options, type
.)
[Enter]
4. The current (or default) configuration of each installed IBM
card will be displayed. Make the necessary change(s) by
selecting a card, then typing
following switches as necessary.
Option
Card
State
Autosense
Data Rate
RPL
I/O Base
RAM Base 1st card:
RAM Range
ROM Base 1st card:
Mem Ctl
Interrupt
* Autosense will automatically read and set the ring speed for each
card except the first card in the ring. For the first card in the ring,
set Autosense to
IBM Token Ring cards (that are software-configurable), set
Autosense to
For example, if changes must be made to make the state Active,
disable RPL, and set the Interrupt to 10, type
/a /f 1 /p 1 /n 10 [Enter]
B-4
[Ctrl] [Alt [Del]
Starting PC-DOS
autocfg /v and press
followed by as many of the
autocfg
Necessary Value
or
0 1
Active
*
ON
or MB/sec *
4 16
Disabled
1st card: hex
0A20
2nd card: hex
0A24
hex
C800
2nd card: D800 hex
16 K
hex
DC00
2nd card: hex
DE00
16-bit
1st card:
IRQ-09
2nd card: IRQ-10
OFF
, and configure a Data Rate. For all other
ON
and leave the Data Rate at the default setting.
.
FRX6000 Maintenance Guide, Rev 03
.
, press .
[F5]
[Enter]. (If you want
autocfg
Switch
or
/c 1 /c 2
/a /f 1
/t 1
or
/d 4 /d 16
/p 1
/i a20
/i a24
/r c8
/r d8
/s 16
/o dc
/o de
/b 16
/n 9
/n 10
(or )
autocfg /c 1 2