Advertisement
pattern pattern
sweep-min-size
sweep-max-size
sweep-interval
ointerface
Defaults
See parameters above.
Command Modes
EXEC
EXEC Privilege
Command
Version 8.4.1.0
History
Version 8.3.1.0
Version 8.2.1.0
Version 8.1.1.0
Version 7.9.1.0
Version 7.6.1.0
Version 7.5.1.0
Version 7.4.1.0
(IPv4 only) Enter the IPv4 data pattern.
Range: 0-FFFF
0xABCD
Default:
Enter the minimum size of datagram in sweep range.
Range: 52-15359 bytes
Enter the maximum size of datagram in sweep range.
Range: 53-15359 bytes
Enter the incremental value for sweep size.
1-15308 seconds
(IPv4 only) Enter the outgoing interface for multicast packets.
•
Enter the IP address in A.B.C.D format
•
For an 100/1000 Ethernet interface, enter the keyword
followed by the slot/port information.
•
For a 1-Gigabit Ethernet interface, enter the keyword
followed by the slot/port information.
•
For a Port Channel, enter the keyword
C-Series and S-Series: 1-128
E-Series: 1 to 32 for EtherScale, 1 to 255 for TeraScale and 1 to 512 for
ExaScale
•
E-Series only For the SONET interfaces, enter the keyword
by slot/port information.
•
For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet
•
For a VLAN interface, enter the keyword
4094.
IPv6 pinging available on management interface.
Introduced extended ping options.
Introduced on E-Series ExaScale (IPv6)
Introduced on E-Series ExaScale (IPv4)
Introduced VRF
Introduced on S-Series
Introduced support for C-Series
Added support for IPv6 address on E-Series
GigabitEthernet
port-channel
followed by the slot/port information.
vlan
followed by a number from 1 to
Control and Monitoring | 97
GigabitEthernet
followed by a number:
sonet
followed
Advertisement
