Advertisement
Command
Version 8.1.1.0
History
Version 7.6.1.0
Version 7.5.1.0
Version 6.1.1.0
Usage
The following commands are not supported by the do command:
Information
•
•
•
•
Example
Figure 5-3. Command Example: do
FTOS(conf-if-te-5/0)#do clear counters
Clear counters on all interfaces [confirm]
FTOS(conf-if-te-5/0)#
FTOS(conf-if-te-5/0)#do clear logging
Clear logging buffer [confirm]
FTOS(conf-if-te-5/0)#
FTOS(conf-if-te-5/0)#do reload
System configuration has been modified. Save? [yes/no]: n
Proceed with reload [confirm yes/no]: n
FTOS(conf-if-te-5/0)#
enable
c e s
Enter the EXEC Privilege mode or any other privilege level configured. After entering this command,
you may need to enter a password.
enable [level]
Syntax
Parameters
level
Defaults
15
Command Modes
EXEC
Command
Version 8.1.1.0
History
Version 7.6.1.0
Version 7.5.1.0
E-Series original Command
Usage
Users entering the EXEC Privilege mode or any other configured privilege level can access
Information
configuration commands. To protect against unauthorized access, use the
configure a password for the enable command at a specific privilege level. If no privilege level is
specified, the default is privilege level 15.
Related
enable password
Commands
Introduced on E-Series ExaScale
Introduced on S-Series
Introduced on C-Series
Introduced on E-Series
enable
disable
exit
config
(OPTIONAL) Enter a number for a privilege level of FTOS.
Range: 0 to 15.
Default: 15
Introduced on E-Series ExaScale
Introduced on S-Series
Introduced on C-Series
Configure a password for the enable command and to access a privilege level.
command to
enable password
Control and Monitoring | 81
Advertisement
