Advertisement
ipg (Gigabit Ethernet interfaces)
e
Syntax
Parameters
Defaults
Command Modes
Command
History
Usage
Information
ipg (10 Gigabit Ethernet interfaces)
e
Syntax
Parameters
Defaults
Command Modes
Command
History
Usage
Information
580
|
Interfaces
Set the Inter-packet gap (IPG) to 8 bytes for traffic on a Gigabit Ethernet interface.
ipg 8
To return to the default setting, enter no ipg.
8
Enter the keyword
12 bytes
INTERFACE
Version 8.2.1.0
Support for 4093 VLANs on E-Series ExaScale. Prior releases supported 2094.
Version 8.1.1.0
Introduced on E-Series ExaScale
pre-Version 6.1.1.0
Introduced for E-Series
For 1-Gigabit Ethernet interfaces only.
Note:
This command is an EtherScale only command.
Set the Inter-packet Gap for traffic on 10 Gigabit Ethernet interface.
ipg {ieee-802.3ae | shrink}
To return to the default of averaging the IPG, enter no ipg
ieee-802.3ae
Enter the keyword
dependent)
shrink
Enter the keyword
averaging the IPG
INTERFACE
pre-Version 6.1.1.0
Introduced for E-Series (
For 10 Gigabit Ethernet interfaces only.
IPG equals 96 bits times from end of the previous packet to start of the pre-amble of the next packet.
8
to set the IPG to 8 bytes.
{
ieee-802.3ae
to set the IPG to 12 (12-15) bytes (packet size
shrink
to set the IPG to 8 (8-11) bytes (packet size dependent).
EtherScale-only)
|
}
shrink
ieee-802.3ae
Advertisement
