Dell Force10 TeraScale E Series Reference Manual page 275

match metric
c e s
Configure a filter to match on a specified value.
match metric metric-value
Syntax
Parameters
metric-value
Defaults
Not configured.
Command Modes ROUTE-MAP
Command
Version 8.1.1.0
History
Version 7.6.1.0
Version 7.5.1.0
pre-Version 6.1.1.0
Related
match interface
Commands
match ip address
match ip next-hop
match ip route-source
match route-type
match tag
match origin
c e s
Configure a filter to match routes based on the value found in the BGP path ORIGIN attribute.
match origin {egp | igp | incomplete}
Syntax
Parameters
egp
igp
incomplete
Defaults Not configured.
Command Modes
ROUTE-MAP
Command
Version 8.1.1.0
History
pre-Version 6.1.1.0
Enter a value to match.
Range: zero (0) to 4294967295.
Introduced on E-Series ExaScale
Support added for S-Series
Support added for C-Series
Introduced for E-Series
Redistribute routes that match the next-hop interface.
Redistribute routes that match an IP address.
Redistribute routes that match the next-hop IP address.
Redistribute routes that match routes advertised by other routers.
Redistribute routes that match a route type.
Redistribute routes that match a specific tag.
egp
Enter the keyword
igp
Enter the keyword
incomplete
Enter the keyword
information.
Introduced on E-Series ExaScale
Introduced for E-Series
to match routes originating outside the AS.
to match routes originating within the same AS.
to match routes with incomplete routing
Access Control Lists (ACL) | 275