Advertisement
Related
Commands
bgp confederation identifier
c e
Syntax
Parameters
Defaults
Command Modes
Command
History
Usage
Information
bgp confederation peers
c e
Syntax
Parameters
Defaults
740
|
IPv6 Border Gateway Protocol (IPv6 BGP)
bgp client-to-client reflection
neighbor route-reflector-client
show ip bgp ipv6 unicast
cluster-list
Configure an identifier for a BGP confederation.
bgp confederation identifier as-number
To delete a BGP confederation identifier, use the no bgp confederation identifier as-number
command.
as-number
Enter the AS number.
Range: 1 to 65535
Not configured.
ROUTER BGP
Version 8.4.2.1
Introduced on C-Series and S4810.
Version 8.2.1.0
Introduced on E-Series ExaScale
Version 7.4.1.0
Introduced on E-Series TeraScale
The autonomous systems configured in this command are visible to the EBGP neighbors. Each
autonomous system is fully meshed and contains a few connections to other autonomous systems. The
next hop, MED, and local preference information is preserved throughout the confederation.
FTOS accepts confederation EBGP peers without a LOCAL_PREF attribute. The software sends
AS_CONFED_SET and accepts AS_CONFED_SET and AS_CONF_SEQ.
Specify the Autonomous Systems (ASs) that belong to the BGP confederation.
bgp confederation peers as-number [...as-number]
To enter no bgp confederation peer.
as-number
Enter the AS number.
Range: 1 to 65535
...as-number
(OPTIONAL) Enter up to 16 confederation numbers.
Range: 1 to 65535.
Not configured.
Enable route reflection between route reflector and clients.
Configure a route reflector and clients.
View paths with a cluster ID.
Advertisement
