Advertisement
Defaults
Command Modes
ipv6 neighbor
e
Syntax
Parameters
Defaults
Command Modes
show ipv6 neighbors
e
Syntax
Parameters
982
|
Neighbor Discovery Protocol (NDP)
Enabled
INTERFACE
Configure a static entry in the IPv6 neighbor discovery.
ipv6 neighbor {ipv6-address} {interface interface} {hardware_address}
To remove a static IPv6 entry from the IPv6 neighbor discovery, use the no ipv6 neighbor
{ipv6-address} {interface interface} command.
ipv6-address
interface interface
hardware_address
No default behavior or values
CONFIGURATION
Display IPv6 discovery information. Entering the command without options shows all IPv6 neighbor
addresses stored on the CP (control processor).
show ipv6 neighbors [ipv6-address] [cpu {rp1 [ipv6-address] | rp2 [ipv6-address]}]
[interface interface]
ipv6-address
Enter the IPv6 address of the neighbor in the
::
The
notation specifies successive hexadecimal fields of zero
interface
Enter the keyword
number information:
•
For a Fast Ethernet interface, enter the keyword
followed by the slot/port information.
•
For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet
followed by the slot/port information.
•
For a Port Channel interface, enter the keyword
followed by a number:
E-Series Range: 1 to 32 for EtherScale, 1 to 255 for TeraScale and 1 to
512 for ExaScale.
•
For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet
Enter a 48-bit hardware MAC address in nn:nn:nn:nn:nn:nn format.
Enter the IPv6 address of the neighbor in the
::
The
notation specifies successive hexadecimal fields of zero
x:x:x:x::x
format.
followed by the interface type and slot/port or
fastEthernet
port-channel
followed by the slot/port information.
x:x:x:x::x
format.
Advertisement
