Advertisement
clear mac-address-table dynamic
c e s
Syntax
Parameters
Command Modes
Command
History
mac accounting destination
e
Syntax
Parameters
868
|
Layer 2
•
show mac learning-limit
Clear the MAC address table of all MAC address learned dynamically.
clear mac-address-table dynamic {address mac-address | all | interface interface | vlan
vlan-id}
address mac-address
all
interface interface
vlan vlan-id
EXEC Privilege
Version 7.6.1.0
Version 7.5.1.0
pre-Version 6.1.1.1
Configure a destination counter for Layer 2 traffic.
mac accounting destination {mac-address vlan vlan-id | vlan} [bytes | packets]
To delete a destination counter, enter no mac accounting destination.
mac-address
vlan vlan-id
bytes
packets
address
Enter the keyword
nn:nn:nn:nn:nn:nn format.
all
Enter the keyword
to delete all MAC address entries in the MAC address
table.
Enter the following keywords and slot/port or number information:
•
For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet
followed by the slot/port information.
•
For a Port Channel interface, enter the keyword
followed by a number:
C-Series and S-Series Range: 1-128
E-Series Range: 1 to 32 for EtherScale, 1 to 255 for TeraScale and 1 to
512 for ExaScale.
•
For a SONET interface, enter the keyword
port information.
•
For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet
vlan
Enter the keyword
followed by a VLAN ID number from 1 to 4094.
Introduced on S-Series
Introduced on C-Series
Introduced on E-Series
Enter the MAC address in the nn:nn:nn:nn:nn:nn format to count Layer 2 packets
or bytes sent to that MAC address.
vlan
Enter the keyword
followed by the VLAN ID to count Layer 2 packets or
bytes sent to the VLAN.
Range: 1 to 4094.
(OPTIONAL) Enter the keyword
(OPTIONAL) Enter the keyword
followed by a MAC address in
port-channel
sonet
followed by the slot/
followed by the slot/port information.
bytes
to count only bytes
packets
to count only packets.
Advertisement
