Advertisement
lacp system-priority
c e s
Syntax
Parameters
Defaults
Command Modes
Command
History
port-channel mode
c e s
Syntax
Parameters
Defaults
Command Modes
Command
History
Usage
Information
864
|
Link Aggregation Control Protocol (LACP)
Configure the LACP system priority.
lacp system-priority priority-value
priority-value
32768
CONFIGURATION
Version 7.6.1.0
Support added for S-Series
Version 7.5.1.0
Support added for C-Series
Version 6.2.1.1
Introduced on E-Series
Configure the LACP port channel mode.
port-channel number mode [active] [passive] [off]
number
Enter the keyword
C-Series and S-Series Range: 1-128
E-Series Range: 1 to 32 for EtherScale, 1 to 255 for TeraScale and 1 to 512 for
ExaScale.
active
Enter the keyword
passive
Enter the keyword
off
Enter the keyword
* The LACP modes are defined in the table below.
off
INTERFACE
Version 7.6.1.0
Support added for S-Series
Version 7.5.1.0
Support added for C-Series
Version 6.2.1.1
Introduced
The LACP modes are defined in the following table.
Enter the system-priority value. The higher the value, the lower the priority.
Range: 1 to 65535
Default: 32768
port-channel
followed by a number:
active
to set the mode to the active state.*
passive
to set the mode to the passive state.*
off
to set the mode to the off state.*
Advertisement
