Advertisement
•
•
channel-member
c e s
Add an interface to the Port Channel, while in the INTERFACE PORTCHANNEL mode.
Syntax
channel-member interface
To delete an interface from a Port Channel, use the no channel-member interface command.
Parameters
interface
Defaults
Not configured.
Command Modes
INTERFACE PORTCHANNEL
Command
Version 8.1.1.0
History
Version 7.6.1.0
Version 7.5.1.0
pre-Version 6.2.1.0
Usage
Use the
Information
You cannot add an interface to a Port Channel if the interface contains an IP address in its
configuration. Only the shutdown, description, mtu, and
interface if it is to be added to a Port Channel. The
the chassis is in Jumbo mode.
Link MTU and IP MTU considerations for Port Channels are:
•
•
Example: If the members have a link MTU of 2100 and an IP MTU 2000, the Port Channel's MTU
values cannot be higher than 2100 for link MTU or 2000 bytes for IP MTU.
show interfaces port-channel
show port-channel-flow
Note:
The FTOS implementation of LAG or Port Channel requires that you configure a LAG
on both switches manually. For information on FTOS Link Aggregation Control Protocol
(LACP) for dynamic LAGs, refer to
For more information on configuring and using Port Channels, refer to the FTOS
Configuration Guide.
Enter the following keywords and slot/port or number information:
•
For a 100/1000 Ethernet interface, enter the keyword
the slot/port information.
•
For a Gigabit Ethernet interface, enter the keyword
the slot/port information.
•
For a SONET interface, enter the keyword
information.
•
For a Ten Gigabit Ethernet interface, enter the keyword
followed by the slot/port information.
interface port-channel
All members must have the same link MTU value and the same IP MTU value.
The Port Channel link MTU and IP MTU must be less than or equal to the link MTU and IP MTU
values configured on the channel members.
Chapter 29, Link Aggregation Control Protocol
Introduced on E-Series ExaScale
Introduced on S-Series
Introduced on C-Series
Introduced for E-Series
command to access this command.
ip mtu
mtu
and ip mtu commands are only available when
GigabitEthernet
GigabitEthernet
sonet
followed by the slot/port
TenGigabitEthernet
commands can be configured on an
(LACP).
followed by
followed by
Interfaces | 617
Advertisement
