Advertisement
mac access-list standard
c e s
Name a new or existing MAC access control list (MAC ACL) and enter the MAC ACCESS LIST
mode to configure a standard MAC ACL. See
MAC Access List
Syntax
mac access-list standard mac-list-name
Parameters
mac-list-name
Defaults
Not configured
Command Modes
CONFIGURATION
Command
Version 8.1.1.0
History
Version 7.8.1.0
Version 7.6.1.0
Version 7.5.1.0
pre-Version 6.1.1.0
Usage
FTOS supports one ingress and one egress MAC ACL per interface.
Information
Prior to 7.8.1.0, names are up to 16 characters long.
The number of entries allowed per ACL is hardware-dependent. Refer to your line card documentation
for detailed specification on entries allowed per ACL.
C-Series and S-Series support ingress ACLs only.
Example
Figure 9-7. Command Example: mac-access-list standard
FTOS(conf)#mac-access-list access-list standard TestMAC
FTOS(config-std-macl)#?
deny
description
exit
no
permit
remark
seq
show
permit
c e s
Configure a filter to forward packets from a specific source MAC address.
Syntax
permit {any | mac-source-address [mac-source-address-mask]} [count [byte]] | [log]
[monitor]
Commands.
Enter a text string as the name of the standard MAC access list (140 character
maximum).
Introduced on E-Series ExaScale
Increased name string to accept up to 140 characters. Prior to 7.8.1.0, names are up to
16 characters long.
Support added for S-Series
Support added for C-Series
Introduced for E-Series
Specify packets to reject
List description
Exit from access-list configuration mode
Negate a command or set its defaults
Specify packets to forward
Specify access-list entry remark
Sequence numbers
Show Standard ACL configuration
Commands Common to all ACL Types
and
Common
Access Control Lists (ACL) | 255
Advertisement
