Advertisement
cpu
interface interface
Defaults
No default behavior or values
Command Modes
EXEC
EXEC Privilege
Example
Figure 36-1. show ipv6 neighbors Command Example
FTOS#show ipv6 neighbors
IPv6 Address
------------------------------------------------------------------------------
fe80::201:e8ff:fe17:5bc6
fe80::201:e8ff:fe17:5bc7
fe80::201:e8ff:fe17:5bc8
fe80::201:e8ff:fe17:5caf
fe80::201:e8ff:fe17:5cb0
fe80::201:e8ff:fe17:5cb1
fe80::201:e8ff:fe17:5cae
fe80::201:e8ff:fe17:5cae
fe80::201:e8ff:fe17:5cae
FTOS#
Enter the keyword
or 2), optionally followed by an IPv6 address to display the IPv6 neighbor
entries stored on the designated RP.
•
For a Fast Ethernet interface, enter the keyword
followed by the slot/port information.
•
For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet
•
For a Port Channel interface, enter the keyword
followed by a number from 1 to 255.
•
For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet
•
For a VLAN, enter the keyword
range is from 1 to 4094.
Expires(min)
Hardware Address
1439
00:01:e8:17:5b:c6
1439
00:01:e8:17:5b:c7
1439
00:01:e8:17:5b:c8
0.3
00:01:e8:17:5c:af
1439
00:01:e8:17:5c:b0
1439
00:01:e8:17:5c:b1
1439
00:01:e8:17:5c:ae
1439
00:01:e8:17:5c:ae
1439
00:01:e8:17:5c:ae
cpu
rp1
followed by either
followed by the slot/port information.
followed by the slot/port information.
vlan
followed by the VLAN ID. The
State
Interface
STALE
Gi 1/9
STALE
Gi 1/10
STALE
Gi 1/11
REACH
Po 1
STALE
Po 32
STALE
Po 255
STALE
Gi 1/3
STALE
Gi 1/5
STALE
Gi 1/7
Neighbor Discovery Protocol (NDP) | 983
rp2
or
(Route Processor 1
fastEthernet
port-channel
VLAN
CPU
-
CP
-
CP
-
CP
-
CP
-
CP
-
CP
Vl 100 CP
Vl 1000 CP
Vl 2000 CP
Advertisement
