Advertisement
interface range
c e s
This command permits configuration of a range of interfaces to which subsequent commands are
applied (bulk configuration). Using the interface range command, identical commands can be
entered for a range of interface.
Syntax
interface range interface , interface , ...
Parameters
interface ,
interface ,
Defaults
This command has no default behavior or values.
Command Modes
CONFIGURATION
Command
Version 8.2.1.0
History
Version 8.1.1.0
Version 7.6.1.0
Version 7.5.1.0
pre-Version 6.1.1.0
Usage
When creating an interface range, interfaces appear in the order they are entered; they are not sorted.
Information
The command verifies that interfaces are present (physical) or configured (logical). Important things to
remember:
•
•
•
•
•
Enter the keyword
...
port-channel or VLAN number. Select the range of interfaces for bulk configuration.
You can enter up to six comma separated ranges—spaces are not required between the
commas. Comma-separated ranges can include VLANs, port-channels and physical
interfaces.
Slot/Port information must contain a space before and after the dash. For example,
interface range gigabitethernet 0/1 - 5
gigabitethernet 0/1-5
•
For a 1-Gigabit Ethernet interface, enter the keyword
followed by the slot/port information.
•
For a Port Channel interface, enter the keyword
number:
C-Series and S-Series Range: 1-128
E-Series Range: 1 to 32 for EtherScale, 1 to 255 for TeraScale and 1 to 512 for
ExaScale.
•
For a SONET interface, enter the keyword
information.
•
For a 10-Gigabit Ethernet interface, enter the keyword
followed by the slot/port information.
•
For a VLAN, enter the keyword
Support for 4093 VLANs on E-Series ExaScale. Prior releases supported 2094.
Introduced on E-Series ExaScale
Introduced on S-Series
Introduced on C-Series
Introduced for E-Series
Bulk configuration is created if at least one interface is valid.
Non-existing interfaces are excluded from the bulk configuration with a warning message.
The interface range prompt includes interface types with slot/port information for valid interfaces.
The prompt allows for a maximum of 32 characters. If the bulk configuration exceeds 32
characters, it is represented by an ellipsis ( ... ).
When the interface range prompt has multiple port ranges, the smaller port range is excluded from
the prompt.
If overlapping port ranges are specified, the port range is extended to the smallest start port and the
biggest end port.
interface range
and one of the interfaces — slot/port,
is not valid.
sonet
vlan
followed by a number from 1 to 4094.
interface range
is valid;
GigabitEthernet
port-channel
followed by a
followed by the slot/port
TenGigabitEthernet
Interfaces | 575
Advertisement
