Advertisement
Defaults
Disabled (The interface is in Layer 3 mode.)
Command Modes
INTERFACE
Command
Version 8.4.1.0
History
Version 8.1.1.0
Version 7.7.1.0
Version 7.6.1.0
Version 7.5.1.0
pre-Version 6.2.1.0
If an IP address or VRRP group is assigned to the interface, you cannot use the switchport command
Usage
Information
on the interface. To use the switchport command on an interface, only the no ip address and no
shutdown statements must be listed in the show config output.
When you enter the switchport command, the interface is automatically added to the default VLAN.
To use the switchport backup interface command on a port, you must first enter the switchport
command. For details, see the Configuring Redundant Links section in the Layer 2 chapter of the
FTOS Configuration Guide.
Related
interface port-channel
Commands
show interfaces switchport
wanport
e
Enable the WAN mode on a TenGigabitEthernet interface.
Syntax
wanport
To disable the WAN Port, enter no wanport.
Defaults
Not configured.
Command Modes
CONFIGURATION
Command
Version 8.1.1.2
History
pre-Version 6.2.1.0
Usage
The port must be in a shutdown state to change from LAN mode to WAN mode and vice-versa as
Information
shown in the figure below.
For E-Series ExaScale systems, you must configure all the ports in a port-pipe to either WANPHY or
non-WANPHY. They cannot be mixed on the same port-pipe.
Added support for port-channel interfaces (port-channel number option).
Introduced on E-Series ExaScale
Added backup interface option.
Introduced on S-Series
Introduced on C-Series
Introduced for E-Series
Create a port channel interface.
Display information about switchport interfaces.
Introduced on E-Series ExaScale
Introduced for E-Series
Interfaces | 615
Advertisement
