Advertisement
Version 7.5.1.0
E-Series original Command
Usage
Optionally, use the banner exec command to create a text string that is displayed when the user
Information
accesses the EXEC mode. The exec-banner command toggles that display.
Example
FTOS(conf)#banner exec ?
LINE
FTOS(conf)#banner exec %
Enter TEXT message.
This is the banner%
FTOS(conf)#end
FTOS#exit
4d21h5m: %RPM0-P:CP %SEC-5-LOGOUT: Exec session is terminated for user on line
console
This is the banner
FTOS con0 now available
Press RETURN to get started.
4d21h6m: %RPM0-P:CP %SEC-5-LOGIN_SUCCESS: Login successful for user
console
This is the banner
FTOS>
Related
banner login
Commands
banner motd
exec-banner
line
banner login
c e s
Set a banner to be displayed when logging on to the system.
Syntax
banner login {keyboard-interactive | no keyboard-interactive} [c line c]
Parameters
keyboard-interactive
c
line
Defaults
No banner is configured and the CR is required when creating a banner.
Command Modes
CONFIGURATION
Introduced on C-Series
c banner-text c, where 'c' is a delimiting character
End with the character '%'.
Sets a banner for login connections to the system.
Sets a Message of the Day banner.
Enable the display of a text string when the user enters the EXEC mode.
Enable and configure console and virtual terminal lines to the system.
Enter this keyword to require a carriage return (CR) to get the message banner
prompt.
Enter a delineator character to specify the limits of the text banner. In
the % character is the delineator character.
Enter a text string for your text banner message ending the message with your
delineator.
In the example in
Figure
Ranges:
•
maximum of 50 lines
•
up to 255 characters per line
5-1, the delineator is a percent character (%).
on line
Figure
5-1,
Control and Monitoring | 75
Advertisement
