Advertisement
Parameters
number
Defaults
Not configured.
Command Modes
CONFIGURATION
Command
Version 8.1.1.0
History
Version 7.6.1.0
Version 7.5.1.0
Version 6.4.1.0
Example
Figure 23-6. interface loopback Command Example
FTOS(conf)#interface loopback 1655
FTOS(conf-if-lo-1655)#
Related
interface
Commands
interface null
interface port-channel
interface vlan
interface ManagementEthernet
c e
Configure the Management port on the system (either the Primary or Standby RPM).
Syntax
interface ManagementEthernet slot/port
Parameters
slot/port
Defaults
Not configured.
Command Modes
CONFIGURATION
Command
Version 8.1.1.0
History
Version 7.5.1.0
Version 6.4.1.0
Figure 23-7. interface ManagementEthernet Command Example
Example
FTOS(conf)#interface managementethernet 0/0
FTOS(conf-if-ma-0/0)#
Usage
You cannot delete a Management port.
Information
The Management port is enabled by default
IP address to the Management port.
Enter a number as the interface number.
Range: 0 to 16383.
Introduced on E-Series ExaScale
Introduced on S-Series
Introduced on C-Series
Introduced
Configure a physical interface.
Configure a Null interface.
Configure a port channel.
Configure a VLAN.
ManagementEthernet
Enter the keyword
number zero (0).
Introduced on E-Series ExaScale
Introduced for C-Series
Introduced for E-Series
(no
followed by slot number (0-1) and port
shutdown). Use the
ip address
command to assign an
Interfaces | 573
Advertisement
