Advertisement
ethertype operator
count
byte
log
monitor
Defaults
Not configured.
Command Modes
CONFIGURATION-MAC ACCESS LIST-EXTENDED
Command
Version 8.1.1.0
History
Version 7.6.1.0
Version 7.5.1.0
Version 7.4.1.0
pre-Version 6.1.1.0
Usage
When you use the log option, CP processor logs details about the packets that match. Depending on
Information
how many packets match the log entry and at what rate, the CP may become busy as it has to log these
packets' details.
Related
permit
Commands
seq
mac access-list extended
c e s
Name a new or existing extended MAC access control list (extended MAC ACL).
Syntax
mac access-list extended access-list-name
Parameters
access-list-name
Defaults
No default configuration
Introduced on E-Series ExaScale
Support added for S-Series
Support added for C-Series
monitor
Added
Introduced for E-Series
Note:
When ACL logging and byte counters are configured simultaneously, byte counters
may display an incorrect value. Configure packet counters with logging instead.
Configure a filter to forward based on MAC addresses.
Configure a filter with specific sequence numbers.
Enter a text string as the MAC access list name, up to 140 characters.
(OPTIONAL) To filter based on protocol type, enter one of
the following Ethertypes:
ev2
•
- is the Ethernet II frame format.
llc
•
- is the IEEE 802.3 frame format.
snap
•
- is the IEEE 802.3 SNAP frame format.
(OPTIONAL) Enter the keyword
processed by the filter.
(OPTIONAL) Enter the keyword
processed by the filter.
(OPTIONAL, E-Series only) Enter the keyword
packets.
(OPTIONAL) Enter the keyword
describing the traffic that you want to monitor and the ACL in
which you are creating the rule will be applied to the
monitored interface. For details, see the section "Flow-based
Monitoring" in the Port Monitoring chapter of the FTOS
Configuration Guide.
option
count
to count packets
byte
to count bytes
log
to log the
monitor
when the rule is
Access Control Lists (ACL) | 259
Advertisement
