Advertisement
Parameters
Defaults
Command Mode
Command
History
ethernet oam link-monitor high-threshold action
s
Syntax
Defaults
Command Mode
Command
History
ethernet oam link-monitor on
s
Syntax
Defaults
Command Mode
Command
History
180
|
802.3ah
{
|
high
milliseconds
none
low milliseconds
window milliseconds
As above
INTERFACE
Version 8.4.1.0
Introduced on S-Series
Disable an interface when the high threshold is exceeded for any of the monitored error conditions.
ethernet oam link-monitor high-threshold action error-disable-interface
Enabled
INTERFACE
Version 8.4.1.0
Introduced on S-Series
Start link performance monitoring on an interface. To stop link monitoring, enter the
command.
link-monitor on
Link monitoring is started on an interface by default when you enable Ethernet OAM with the
command.
oam
ethernet oam link-monitor on
Enabled
INTERFACE
Version 8.4.1.0
Introduced on S-Series
}
Specify the high threshold value for frame error seconds per time
period, or disable the high threshold.
Range: 1-900
Default: None
Specify the low threshold for frame error seconds per time period.
Range: 1-900
Default: 1
Specify the time period for error second per time period condition.
Range: 100-900, in multiples of 100
Default: 1000 milliseconds
no ethernet oam
ethernet
Advertisement
