Dell Force10 TeraScale E Series Reference Manual page 767

neighbor next-hop-self
Allows you to configure the router as the next hop for a BGP neighbor. (This command is used for
c e
IBGP).
Syntax neighbor {ipv6-address | peer-group-name} next-hop-self
To return to the default setting, use the no neighbor {ipv6-address | peer-group-name}
next-hop-self command.
Parameters
ipv6-address
peer-group-name
Defaults Disabled.
Command Modes
ROUTER BGPV6-ADDRESS FAMILY
Command
Version 8.4.2.1
History
Version 8.2.1.0
Version 7.4.1.0
Usage
If the
Information
precedence over the
neighbor peer-group (assigning peers)
Allows you to assign one peer to a existing peer group.
c e
Syntax neighbor ipv6-address peer-group peer-group-name
To delete a peer from a peer group, use the no neighbor ipv6-address peer-group
peer-group-name command.
Parameters
ipv6-address
peer-group
peer-group-name
Defaults
Not configured.
Command Modes ROUTER BGP
Command
Version 8.4.2.1
History
Version 8.2.1.0
Version 7.4.1.0
Introduced on C-Series and S4810.
Introduced on E-Series ExaScale
Introduced on E-Series TeraScale
set ipv6 next-hop command in the ROUTE-MAP mode is configured, its configuration takes
neighbor next-hop-self
Introduced on C-Series and S4810.
Introduced on E-Series ExaScale
Introduced on E-Series TeraScale
Enter the IPv6 address in the
::
The notation specifies successive hexadecimal fields of zeros.
(OPTIONAL) Enter the name of the peer group.
command.
Enter the IPv6 address in the
::
The notation specifies successive hexadecimal fields of zeros.
peer-group
Enter the keyword
peer group. (maximum 16 characters)
IPv6 Border Gateway Protocol (IPv6 BGP) | 767
x:x:x:x::x
format.
x:x:x:x::x
format.
followed by the name of a configured